The 4 NR adaptor is a cost effective way of connecting up to localized 4-20mA sensors or analog inputs to our RF0600 RS485 transceiver or the RF0523 Wireless Manager. These can be daisy chained using RS485 connections for an additional 264 inputs per transceiver. Each input signal will work with our software as if it were a standard wireless sensor input. NOTE: Item is discontinued - 1 still in stock.
Features:
Onboard linearization circuit
4 channel design
Each channel is polled every 12 seconds
Supports 256 sensors (64 4 channel units)
Modules are connected via RS 485
Transient protected
Single 4 conductor CAT 5 cable
Two conductors for power, two conductors for signal
Up to 4000 feet without a RS 485 repeater
Power requirements: 6-35 volts DC, 6-24 volts AC, 3 milliamp current draw
Transmits standard data packets
Standard pushbutton for service mark
Transmits all 4 channels sequentially
Specification:
You can wire the RF0363 Sensor to an RF0560 Receiver and Transmit at 100 mw
You can wire the 4NRs directly to a Wireless Manager.